Author: Anthony Travis

“lithium ion battery bike _battery for e bike”

You’ve done your math correctly, though that “1000W” figure is largely arbitrary, and probably not the exact power level of the kit. Most 1000W kits I’ve seen use controllers in the 20-25A range, but it can vary greatly. First of all, NCR18650B cells cannot be discharged at 2C. Those are 5A MAX cells, and really you should keep them closer to 1C to keep them cool and happy. They are economical cells. They do better when in large parallel groups so you can take advantage of their high capacity without the downside of their low discharge rate. They are great cells, but not for low AH packs. Electric bikes are a reliable source of transportation. With a new battery from Batteries Plus Bulbs, you can expect the same level of reliability. Our high capacity, replacement batteries will get your scooter moving again and keep it running for a long time. The battery cells have now been assembled into a larger 36V pack, but I still have to add a BMS to control the charging and discharging of the pack. The BMS monitors all of the parallel groups in the pack to safely cut off power at the end of charging, balance all the cells identically and keep the pack from being over-discharged. This is a very simple layout where each column of 3 cells is connected in parallel and then the...

Read More

“bike battery packs ebike battery pack”

Different batteries have different amperage capacities. Most cheap lithium batteries are not capable of putting out much amperage. If you have a 48 volt bike that performs well when using 25 amps, you are going to want a 48 volt battery that has close to a 20-Amp-hours or more.  If you want to eventually hot rod your ebike (read our hot rod hub motor primer here), you may want to  invest now in a high amperage battery. This will “future proof” your system by paying a little bit more now for the battery, but then you can program more performance from the controller in the future, if you want… Hey, I’m about to build my 16S2P pack from 32 Samsung INR18650-25R cells bought from batterybro.com. How far apart can their voltages be when you connect the parallel packs? They seem to all be charged between 3.52V and 3.56V. Great for DIY e-bike and powerwall builders, t ake them apart and put them all together in series in other projects and get extreme power out of what you build! These batteries are made with TWENTY (2… One other unrelated question: Do commercially available eBike batteries generally use off-brand cells for their assembled batteries to bring cost down, or similar to the cells, do reliable eBike companies use name-brand cells and off-brand internet vendors use off-brand cells? I also soldered rather...

Read More

“bike batteries online -battery for ebike”

7. Winner selection and notification: Winners of the Sweepstakes will be selected in a random drawing under the supervision of the Sponsor. Winners will be notified via e-mail to the e-mail address they entered the Sweepstakes with within five (5) days following the winner selection. Electric Bike Technologies LLC shall have no liability for a winner’s failure to receive notices due to winners’ spam, junk e-mail or other security settings or for winners’ provision of incorrect or otherwise non-functioning contact information. If the selected winner cannot be contacted, is ineligible, fails to claim the prize within 15 days from the time award notification was sent, or fails to timely return a completed and executed declaration and releases as required, prize may be forfeited and an alternate winner selected. The receipt by winner of the prize offered in this Sweepstakes is conditioned upon compliance with any and all federal and state laws and regulations. ANY VIOLATION OF THESE OFFICIAL RULES BY ANY WINNER (AT SPONSOR’S SOLE DISCRETION) WILL RESULT IN SUCH WINNER’S DISQUALIFICATION AS WINNER OF THE SWEEPSTAKES AND ALL PRIVILEGES AS WINNER WILL BE IMMEDIATELY TERMINATED. NiCd-Nickel Cadmium. This chemistry was half the size per a given power compared to SLA. But it has a low C-rate (Current producing capability) so anyone who made a pack out of them was restricted to low amps. There were no large packs...

Read More

“bike batteries +bike batteries for sale”

Alternately, you can separate the batteries and charge each with its own charger, but then you have some small risk of reconnected the batteries when one is charged and the other is flat, if for some reason one of the batteries didn’t get charged up properly. We usually recommend leaving the packs parallel connected at all times. Sorry if this has been asked already but there are a ton of comments to wade through. Ten individual 18650 cells in series at a nominal voltage of 3.6 Volts would give me 36 volts. Assuming they are 2500 mAh a piece, then if I put 4 of these 10 cell in series packs together in parallel I would have a 10 Amp Hour battery correct? The same applies if I were to wire a pack together with 10 “4p” cells together in series. I’m trying to determine what the benefit of 10s4p over I guess what would be “4s10p”. One of the first advantages of lithium batteries is their small size. You can fit a lot of lithium on a bicycle frame. This alone can give your ebike some seriously impressive range. Two or three mid to large capacity lithium batteries could easily fit on one ebike, giving potential ranges of 100 miles (160 km) or more. I guess this would be great for people that don’t mind sitting on their...

Read More

“bike battery price -bike battery”

hello sir. nice guide FOR battery pack li-ion… i will try an electric bike kit for my 26″ MTB. and buy 1000w hub motor kit. i can solve my battery problem (expensive you know) with li ion pack. i have some questions, 36V 10ah Lithium battery (Included with the battery is the charger and mounting Bracket). Standard 26 in Front Wheel 500w brushless motor hub (works with V-brake or disc brakes). Pedal Assistance syst… i am building a 10s4p 36v 18650 battery pack for my ebike, what gauge silicon wire you recommend for discharge and charge wires, i am using 2.5 amp 42.5v li-ion battery charger bought from ebay(http://www.ebay.com/itm/281639749374?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT), and 10s 36v 30amp bms bought from ebay(http://www.ebay.com/itm/182247900118?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT) and 500w 36v controller. With a budget in mind, here is a 36V charger (output 42V, exactly what a 36V li-ion pack needs) that I have used and found to be a good budget charger. It’s not super fast, at only 2A, but for just $20 shipped, it’s a great deal. You might have to wait about 3 weeks for it arrive from China though. http://www.aliexpress.com/item/100-240VAC-42VDC-2-0A-Lithium-LiPo-Battery-Charger-E-Bike-charger-suitable-for-10S-36V/559929087.html Battery chargers for electric bike batteries need to be specific for that voltage and type of battery. Lead batteries need a charger that trickle charges when finished, while lithium battery chargers do not trickle charge. E-Bikekit batteries are sold with the correct charger that matches the...

Read More