Month: September 2017

“e-bike battery -diy lithium ion battery”

Also changing the fuse to a higher one could cause the wires to start a fire and the whole house would burn down if the wires are not thick enough. Also in sweden a fuse gets bigger as they are rated higher so you can fit a 20A fuse in a 10A slot, for safety. Battery manufacturers are continuing to research for developments in dozens of battery chemistries, and a couple of years ago, a big improvement to LiPo/LiCo chemistries began to be produced. A high-Cobalt cathode (LiCo) provides very good power density, but how can we make it more stable and reliable? Here’s a quote from batteryuniversity.com The SLA electric bike battery is a reliable power source for electric bikes that are used for shorter trips. The best lifespan for an SLA battery is obtained by keeping it fully charged as much as possible, and discharging it only to half its actual capacity. It’s an affordable electric bike battery, ideal for round trips of 5 to 8 miles, when it can be recharged right away. In typical electric bike use, SLA electric bike batteries last about a year, but longer life is possible if the use is very light, and the battery is kept fully charged at all times. Good question. The answer comes down to the difference between “nominal voltage” and “actual voltage”. LiFePO4 cells are nominally...

Read More

“batteries for electric bicycles -e-bike batteries”

I guess I’ll just have to risk some deterioration on the cells. I don’t think there’s much of an effect, as I did it on an old 18650 cell to test. The joint and https://en.wikipedia.org/wiki/Electric_bikes areas were cool to the touch within 1-2s of removing the heat. Cool project! I’d check out electric rider (www.electricrider.com) as I know they have some good electric rickshaw and electric tricycle kits. You’re looking for a strong 48V motor that is geared really low. You want torque, not speed. With slow speed, something in the 1,000 – 1,500W is probably enough. Just don’t expect to be flying down the road… You’re absolutely right that doubling the capacity of the battery by running two packs in parallel will essential halve the load on each pack, but I still don’t think it would get it down to the level that you could rely on compression fit spring contacts to safely carry that current, let alone the balance issue of not having the 4 groups individually paralleled at the cell level. There are two prevalent ideas in pack constructing in these modern days…one is to use larger pouch-like soft cells to construct the pack. The stealthiest battery chemistry by far is LiPo, large cells with power-dense cobalt in the anode chemistry, such as what comes in Hobby King cells. Here is what I mean by “large cell” LiPo....

Read More

“18650 battery pack diy _battery for ebike”

In the event of a fire, evacuating the building is more important than fighting the fire. Calling the fire department (911) is essential. Keeping yourself safe and not breathing the fumes is more important than saving property. Even if the fire is safely moved outside, call 911, for these fires are tough to extinguish. and i also have another question if i charge the 2 packs seperately then connect them to my bike in parallel do they both have to have the same capacity and the same wear for instance i currently have 2 sets of batteries (sla’s) one of which is an old set at half original capacity or there abouts and the new ones hold the full charge so can they be connected together to give me 1 1/2 x my range? or if im going to put a double pack on do i have to use and charge them together so theyre all at the same state of charge and wear the same as ideally i would like to only have to carry a second pack when i require the extra range. Furthermore, if you have more capacity than required, then you also have the opportunity to do partial charging of the battery with a Satiator or similar device, so that instead of charging the pack to 100% to squeeze out every km, your standard charge...

Read More

“battery for electric bike price |diy lithium ion battery”

If not possible, try charging them individually. Some of them might come back but others might be dead. The tricky thing is that they will likely not be able to deliver their full capacity anymore and the actual capacity will likely vary from cell to cell. Two year old cells at a very low voltage are quite a gamble. Assuming the original battery is a li-ion battery and has the same number of cells in series (same voltage), then yes it should charge it. However, looking at the picture of the battery in that listing, I can tell you that is not a picture a 24V 25AH battery. That picture has 6 cells, and a 24V 25AH battery will have something more like 56 cells. That picture looks like a 22V 3AH battery. It could be that they simply used the wrong picture in the listing, though I doubt it as that would be an insanely good price for that size of a battery. but I’d be wary of that offer either way. I love this article and I am inspired by the knowledge here, I have a question, I need to build a 72v battery and the one I’m looking at is using 38160 cells, these cells are very expensive so how can I manage this the best using the smaller normal size cells like you’re using! Do...

Read More
  • 1
  • 2