Month: July 2016

“ebike battery -build battery pack”

Now buckle up, grab a drink and get ready for some serious reading, because this isn’t a short article. But it will definitely be worth it in the end when you’re cruising around on your very own DIY ebike battery! The exact amount of range you’ll get per battery and motor varies greatly and depends on factors like terrain, speed, weight, etc. Suffice it to say though that if you double your current battery capacity, you’ll see an approximate doubling of your range as well. That might of sounded confusing, so let’s talk in real numbers. My pack is about 70 mm high and about 65 mm wide. That means that half of the perimeter of my pack is 70+ 65 = 135 mm. So I need some heat shrink tubing that has a flat width (or half circumference) of between 135 to 270 mm, or to be safer, more like between 150-250mm. And if possible, I want to be on the smaller end of that range so the heat shrink will be tighter and hold more firmly. Luckily, I have some 170mm heat shrink tube which will work great. Panasonic and Samsung are the only manufacturers I know of that are producing this chemistry (several other manufacturers buy these and re-label them as their own). Since you would have to buy the bare cells in order to solder together...

Read More

“battery for ebike |48v electric bike battery uk”

I then put one set of welds on each cell end of the first parallel group, effectively tacking the three nickel strips in place. Then I added another set of welds on each of the negative terminals of the second parallel group. This gave me 6 weld sets, or one weld set for each cell. Lastly, I followed up those single weld sets with another couple welds per cell to ensure good contact and connection. I have found this BMS which is cheap (necessary for my project) and it is shipped from the UK. Because it is so cheap do you think that it may not be balancing? http://www.ebay.co.uk/itm/400984825723?euid=0502c7e2b2c744ec8857879d65d46e08&cp=1 Lithium Iron Phosphate is currently the most common lithium battery used in Ebike applications. It is considered the most stable lithium battery type available today (low risk of fire) and has a reasonably high life expectancy of over 1000 charges. Yes, it’s technically possible, but sometimes it is easier said than done. If the cells are on the edge of your battery, it’s much easier to cut them out (by the nickel, not by cutting the actual cell!) and replace them. If they are sandwiched in the middle of your pack then you’ll have to do a lot more pack surgery to get in and replace them. But yes, it’s possible to just remove them and replace them with new, good cells of...

Read More